Lecture notes for ECE 614 Advanced Analog IC Design, Fall 2009

 

December 9 – final exam

December 7 – lec25_ece614.pdf and lec25_ece614_video – capacitor error averaging, review for final

December 2 – lec24_ece614.pdf and lec24_ece614_video – pipeline ADC and the use of 1.5 bits/stage

November 30 – lec23_ece614.pdf and lec23_ece614_video – ADC building blocks, the cyclic ADC

November 25 – Thanksgiving break from instruction

November 23 – Thanksgiving break from instruction

November 18 – lec22_ece614.pdf and lec22_ece614_video – DACs that don’t use an op-amp, op-amps in data converters

November 16 – lec21_ece614.pdf and lec21_ece614_video – error sources in pipeline ADCs, implementing R-2R DACs

November 9 – lec20_ece614.pdf and lec20_ece614_video – ADC architectures

November 4 – lec19_ece614.pdf and lec19_ece614_video – DAC architectures

November 2 – lec18_ece614.pdf and lec18_ece614_video – data converter fundamentals

October 26 – midterm exam covering Chs. 8, 25, and 26

October 21 – lec17_ece614.pdf and lec17_ece614_video – review for the exam

October 19 – lec16_ece614.pdf and lec16_ece614_video – op-amp design for SC circuits, finish up Ch. 26

October 14 – lec15_ece614.pdf and lec15_ece614_video – effects of offsets, finish continuous-time design, design using SC CMFB

October 12 – lec14_ece614.pdf and lec14_ece614_video – continue with the design of fully-differential op-amps

October 7 – lec13_ece614.pdf and lec13_ece614_video – more CMFB, stability, continue with op-amp design

October 5 – lec12_ece614.pdf and lec12_ece614_video – CMFBs, start basic op-amp design

September 30 – lec11_ece614.pdf and lec11_ece614_video – start Ch. 26 on op-amps II

September 28 – lec10_ece614.pdf and lec10_ece614_video – switched-capacitor circuits, offset storage

September 23 – lec9_ece614.pdf and lec9_ece614_video – dynamic analog circuit design, S/H, bottom-plate sampling

September 21 – lec8_ece614.pdf and lec8_ece614_video – finish up noise modeling, low noise design

September 16 – lec7_ece614.pdf and lec7_ece614_video – MOSFET noise modeling, noise performance of amplifiers, mirrors, etc.

September 14 – lec6_ece614.pdf and lec6_ece614_video – op-noise modeling with simulation examples

September 5 – lec5_ece614.pdf and lec5_ece614_video – op-amp noise modeling and feedback

September 2 – lec4_ece614.pdf and lec4_ece614_video – averaging noise, shot and flicker noise, measurement time

August 31 – lec3_ece614.pdf and lec3_ece614_video – more SNR and input-referred noise, NF, optimum source resistance

August 26 – lec2_ece614.pdf and lec2_ece614_video – input-referred noise, thermal noise, kT/C noise, SNR

August 24 – lec1_ece614.pdf and lec1_ece614_video – course introduction, start Ch. 8 on noise, PSD, NEB, noise measurements

 

Return